H-CLIP CRIMPING MACHINE

An H-hook or H clip is used to join the ends of cylindrical and conical tubes on the tube crimping machine. Crimping with this type of technique results in smooth edges on the crimped section. The pleated pack is thus protected from any media damage. As opposed to spot welded end joints, the hook or clip does not corrode. When compared to spot welded joints, the hooks or clips do not corrode. Therefore, there is no damage to the pleated pack. The hook or clip does not corrode as compared to spot welded end joints.
Tubes up to 900mm in length can be used
Dimensions: 150mm to 650mm
Sheet thickness: up to 1mm expanded sheet
The upper crimping tool has a length of 60mm
Maximum cutting force: 1 ton (adjustable)
900mm (throat depth) is the lower arm length
Auto-cycle programmable for the foot pedal (option)
Low arm support for reduced flexing (36" long liner)
Roller bearing supported crimping tool
Tank capacity: 30 ltr
Cylinder: dia 50x100mm stroke
Lower arm diameter: 125mm
Lower arm and crimping tool hardened to 50 HRC
Adjustable support below lower arm to get more info support filter.